Get Started; Install The Car Audio - Philips CEM3100 User Manual

3 Get started

Caution
Use the controls only as stated in this user manual.
Always follow the instructions in this chapter in
sequence.

Install the car audio

These instructions are for a typical installation.
make the corresponding adjustment. If you have
your car audio dealer.
Caution
This unit is designed for negative ground (earth) 12 V
DC operation only.
Always install this unit in the car dashboard. Other
locations can be dangerous as the rear of the unit heats
up during use.
the ignition is off.
Ensure that you connect the yellow and red power
supply leads after all other leads are connected.
Ensure that all loose leads are insulated with electrical
tape.
Ensure that the leads do not get caught under screws
orin parts that will move (e.g. seat rail).
Ensure that all ground (earth) leads are run to a
common ground (earth) point.
Use only the supplied mounting hardware for a safe
and secure installation.
Note on the power supply lead (yellow)
When you connect other devices to this
circuit is higher than the total fuse value of
all the connected devices.
Notes on speaker connection
Never connect speaker wires to the metal
body or chassis of the car.
Never connect speaker wires with stripes
to one another.
Connection: for cars with ISO
connectors
Caution
Ensure that all loose leads are insulated with electrical
tape.
Note
Consult a professional to connect CEM3100 as
instructed below.
1
Connect the supplied male connector to
the unit.
2
Check the car's wiring carefully and
connect them to the the supplied male
connector.
Note
Risk of danger! Please consult a professional to perform
the below steps!
EN
9