Ping - EverFocus ES0802-41 User Manual

Ping

This command sends ICMP echo request packets to another node on the network.
Ping Parameters
 Target IP Address: IP address of the host
 Count: Number of packets to send. (Range: 1-20)
 Time Out: setting the time period of host will be Ping
Use the ping command to see if another site on the network can be reached.
The following are some results of the ping command:
 Normal response: The normal response occurs in one to ten seconds, depending on network
traffic.
 Destination does not respond: If the host does not respond, a "timeout" appears in ten
seconds.
 Destination unreachable: The gateway for this destination indicates that the destination is
unreachable.
 Network or host unreachable: The gateway found no corresponding entry in the route table.
Press <Esc> to stop pinging.
Figure 2-6-4
30
PoE Switch