Table of Contents
Advertisement
changing states (i.e., discarding to learning to forwarding). Number between 4 –
30 (default is 15).
Force Version: Set and show the RSTP protocol to use. Normal - use RSTP,
Compatible - compatible with STP.
RSTP Port Configuration
Port: The port ID. It cannot be changed. Aggregations mean any configured trunk
group.
Enabled: Click on the tick-box to enable/disable the RSTP protocol for the port.
Edge: Expect the port to be an edge port (linking to an end station) or a link to
another STP device.
Path Cost: This parameter is used by the STP to determine the best path between
devices. Therefore, lower values should be assigned to ports attached to faster
media, and higher values assigned to ports with slower media. Set the RSTP
pathcost on the port. Number between 0 - 200000000. 0 means auto generated
pathcost.
Figure 1-8-1
15
PoE Switch
Advertisement
Table of Contents
