Assembly And Use For The Single Serve Cup - Ninja BL660 Owner's Manual

Assembly and Use for the Single Serve Cup

ASSEMBLY
Fig. 1 Fig. 2
IMPORTANT: Make sure that the motor
base is plugged in for use.
1 Place the motor base on a clean, dry, level
surface such as a counter or table top.
2 Add ingredients to the single serve cup.
3 Place the single serve blade onto the cup and
screw it tightly until you have a good seal.
(Fig. 1)
4 Turn the single serve cup upside down and
place it onto the motor base, aligning the tabs
on the cup with the motor base. Turn to the
left, the unit is ready for use. (Fig. 2)
5 Press down on the Single Serve button in
short intervals to activate. (Fig. 3)
BL660_30_IB_ENG_111222_1.indd 8
PULSE
Fig. 3
For best results, use short "PULSES"... Practice makes perfect!!
Fig. 4
6 When you have reached your desired
consistency, stop the appliance by removing
your hand from the Single Serve button. Then
turn the single serve cup to the right (Fig. 4)
and pull straight up to remove. (Fig. 5)
NOTE: Do not overfill! To avoid spilling, do
not add ingredients past the "Max" fill line.
7 Turn the cup upright and remove the single
serve blade by twisting the blade assembly to
the left.
8 Place the To-Go drinking lid onto the single
serve drink cup, twist to seal and enjoy!
9 Make sure that the motor base is unplugged
when not in use.
www.ninjakitchen.com
REMOVAL
Fig. 5
8
11-12-28 3:46 PM