Tq-3 Radio System Rules - Traxxas E-Maxx 3906 Owner's Manual

The Traxxas TQ-3 Radio System

TQ-3 Radio System Rules

Remember, always
turn the TQ-3
transmitter on first
and off last to avoid
damage to your E-Maxx.
Your EVX
electronic speed
control was set up
with the radio from the
factory. It is possible for
the throttle trim control
on the transmitter to have
moved during transit or
while handling the
transmitter. If the motors
run when the truck (EVX)
is switched on, then turn
the throttle trim control
on the transmitter until
the wheels stop. If
anything more than a
slight adjustment of the
throttle trim control is
required, then you should
readjust your speed
control. Refer to the
Adjustments section on
pages 25 and 26.
18
Each time you prepare to run your
E-Maxx, you must clear your frequency
to be sure no one else in the area is
using the same channel as you.
There are six possible channels,
numbered 1 through 6. Each is
represented by a color. Look at the
crystal plugged into the back of your
transmitter to determine which channel
your truck is assigned to.
Always turn your TQ-3 transmitter on first and off last. This
procedure will help to prevent your E-Maxx from receiving
stray signals from another transmitter, or other source, and
running out of control.
Always have the transmitter turned on before you plug in
the battery packs in the model.
1
Always use new or freshly charged batteries for the radio
Channel 1
system. Weak batteries will limit the range of the radio signal
Brown
between the receiver and the transmitter. Loss of the radio
Channel 2
signal can cause you to lose control of your E-Maxx.
Red
Channel 3
Orange
Channel 4
Yellow
Channel 5
Green
Channel 6
Blue
2 3