Additional Information; Troubleshooting; Additional Information Troubleshooting - Pioneer AVH-P6500DVD Operation Manual

Appendix

Additional Information

Troubleshooting

Common
Symptom
Power doesnt turn on.
The unit doesnt operate.
Operation with the remote con-
trol isnt possible.
The unit does not operate cor-
rectly even when the appropriate
remote control buttons are
pressed.
Playback is not possible.
No sounds are heard.
The volume level will not rise.
Theres no picture.
The icon is displayed, and op-
eration is not possible.
The picture stops (pauses) and
the unit cannot be operated.
Theres no sound.
Volume level is low.
Theres audio and video skip-
ping.
The picture is stretched, the as-
pect is incorrect.
88
En
Cause
Leads and connectors are incor-
rectly connected.
The fuse is blown.
Noise and other factors are causing
the built-in microprocessor to oper-
ate incorrectly.
The remote control operation mode
is incorrect.
The remote control code is incor-
rect.
Battery power is low.
Some operations are prohibited
with certain discs.
The disc is dirty.
The loaded disc is a type this unit
cannot play.
Non compatible video system disc
is loaded.
Cables are not connected correctly.
The unit is performing still, slow mo-
tion or frame-by-frame playback.
The parking brake cord is not con-
nected.
The parking brake is not applied.
The operation is prohibited for the
disc.
The operation is not compatible
with the discs organization.
Reading of data has become impos-
sible during playback.
The volume level is low.
The attenuator is on.
This unit is not firmly secured.
The aspect setting is incorrect for
the display.
Action (See)
Confirm once more that all connections are
correct.
Rectify the reason for the fuse blowing, then
replace the fuse. Be very sure to install the
correct fuse with the same rate.
Press RESET. (Page 11)
Switch to the correct remote control mode.
(Page 16)
Make sure the remote control selection
switch setting and code type setting are the
same. (Page 80)
Load new battery. (Page 12)
Check using another disc.
Clean disc. (Page 91)
Check what type the disc is.
Change to a disc compatible to your video
system.
Connect the cables correctly.
There is no sound during still, slow motion or
frame-by-frame playback.
Connect a parking brake cord, and apply the
parking brake.
Connect a parking brake cord, and apply the
parking brake.
This operation is not possible.
This operation is not possible.
After pressing g once, start playback once
more.
Adjust the volume level.
Turn the attenuator off.
Secure this unit firmly.
Select the appropriate setting for your display.
(Page 79)