Setting Up The Printer - Epson EU-42 Setup Manual

Setting Up the Printer

To prepare the printer for use with the copy station, you need to
install the interface board, ROM module, and large capacity paper
unit, then place the printer into the cabinet. Follow the steps in
this section.
w
Warning:
Be careful when working inside the printer as some components
are sharp and may cause injury.
c
Caution:
Before you install the modules, be sure to discharge any static
electricity by touching a grounded piece of metal. Otherwise, you
may damage static-sensitive components.
1. Unpack the printer as explained in the printer's Unpacking
Guide, then follow the instructions in the printer's Setup Guide
to carry out the following procedures.
Installing the face-up tray
Installing the toner cartridges
Installing the photoconductor unit
2. Make sure that the printer is not plugged in.
Setting Up the Printer
17