HP 800 Installation Manual page 15

2. If your new hard drive is from a different manufacturer than the old one, it may
have screws in different positions. Determine which mounting holes you need;
then, if necessary, push out rubber screw-hole covers from the inside using a
bent paper clip. (From the outside of the computer, insert the rubber covers
into the holes you won't need.)
If your new hard drive has screws in different positions from the old one, you
will also need to adjust the insulator sheet. Compare the location of the screw-
holes in the new hard drive with those in the insulator sheet. If there is no screw
at position A, then unfold the flap at position A, and lay it flat before laying the
hard drive down on the insulator.
A
3. Grasp the right flap and pull to the left to engage the connection between the
hard drive and the computer. Then fold the protective sheet back over the hard
drive.
Using OmniBook Disk Drives
Replacing a Hard Drive
Connectors align here.
1-15