Pppoe Support; Figure 144 Smt: Wan Configuration: Pppoe; Table 69 Smt: Wan Configuration: Static Or Dynamic Ip Address - ZyXEL Communications VSG-1200 User Manual

VSG-1200 User's Guide
The follow table describes the fields in this menu.

Table 69 SMT: WAN Configuration: Static or Dynamic IP Address

FIELD
WAN Type? (D/S/
P/T)
IP Address
Subnet Mask
Default Gateway
Primary/
Secondary DNS IP
Address
At the "S)ave and return R)eturn without saving M)odify:" prompt, type S and press [ENTER] to save the
changes and return to the previous screen, type R and press [ENTER] to discard all changes and return
to the previous screen or type M and press [ENTER] to continue configuring the fields. Restart the
device when prompted
Press [ESC] and enter Y to stop any actions in the current screen and return to the previous screen. All
changes will be discarded.

27.2.2 PPPoE Support

To activate PPPoE support on the VSG, enter P in the WAN Type field to display the WAN
Configuration screen as shown next. Refer to the related web configurator section for
background information.

Figure 144 SMT: WAN Configuration: PPPoE

WAN Type? (D/S/P/T)
Username
Password
Connect Setting? (C/K)
Max idle Time(Min)
Optional Setting
Service name
PPP MTU Setting
TCP MSS setting
208
DESCRIPTION
Enter D (Dynamic) to set the VSG to dynamically obtain an IP address and other
network information (IP address, DNS information etc.) from a DHCP server on the
WAN network. This is the default setting.
Enter S (Static) to set the VSG to use a static (or fixed) IP address. Then set the
following fields.
This field is available when you select S in the WAN Mode field.
Enter the static IP address assigned to you by your ISP or network administrator.
This field is available when you select D in the WAN Mode field.
Enter the subnet mask depending on your network needs. The default is
255.255.255.0. Refer to Appendix H, "IP Subnetting," on page 265
implementing subnetting.
Enter the IP address of the default gateway.
Enter the IP address of the DNS server(s) in the Primary DNS IP Address and/or
Secondary DNS IP Address fields.
The default primary DNS server IP address is 168.95.1.1.
You must specify a DNS server if you set the VSG to use a static WAN IP address.
WAN Configuration
:P
:
:
:C
:10
:
:1492
:1452
Chapter 27 LAN and WAN Setup Using the SMT
if you are