Parts Identification; Placement And Operation - Ideal Air Dehumidifiers Owner's Manual

Parts Identification

1
2
4
5
1
2
3
ACCESSORIES
Nipple (1) Hose Adapter (1)
NOTE: All illustrations in this manual are for explanation purposes only. The appearance of the
unit you purchased may be slightly different, but the operation and functions are the same.
FRONT
6
1
3 Control Panel
2
Air Intake Grille
3 Air Outlet Grille
4 Air Filter (behind the grille)
5 Water Tank
6 Top Carrying Handle (both sides)
REAR
1 Drain Hose Outlet
4
2 Wheel Caster
3
Power Cord and Plug
4
Band (used only when
storing the unit)
Screws (2)
6
PLACEMENT
This unit must be operated in an enclosed area to be most effective. Make sure to close
doors, windows and other outside openings to the room. Do not place the unit near a clothes
dryer, heater or radiator.
NOTE: Operating the unit in a basement will have little or
no effect in drying an adjacent enclosed area (such as a
closet) unless there is adequate air circulation in
and out of the adjacent area.
• Do not use outdoors.
• This dehumidifier is intended for indoor
residential use only. It should not be used
for commercial or industrial applications.
• Place the dehumidifier on a smooth, level
surface strong enough to support the unit
with a full tank of water.
• Allow at least 8" (20cm) of air space on all
sides and 16" (40cm) above for adequate
air circulation. (Fig. 1)
• Place the unit in an area where the temperature
will not fall below 41ºF/5ºC. The coils can become
covered with frost below 41ºF/5ºC, which
may reduce performance.
OPERATION
• Plug the unit into a grounded electrical socket only.
• Do not connect the dehumidifier to an outlet being used for other electrical appliances.
• When first using the dehumidifier, operate it continuously for 24 hours.
• This unit is designed to operate in a working environment between 41ºF/5ºC and 95ºF/35ºC.
• If the unit is switched off and then switched on again quickly, allow approximately 3 minutes for
previous operation to resume.
• Make sure the water tank is correctly fitted, otherwise the unit will not operate properly.
NOTE: Empty the water tank before moving the unit, otherwise it may tip over and spill water.

Placement and Operation

At least
16" (40cm)
.
Air intake
grille
A
Fig. 1
A
A
A = At least 8" (20cm)
NOTE: Make sure wheel casters
can move freely. Do not force the
unit over carpet or move it with
water in the bucket or it may tip
over and/or spill water.
7
Air outlet
grille
A