Usb Connection - JVC RX-D205S Instructions Manual

Digital connection
This receiver is equipped with three DIGITAL IN terminals—one
digital coaxial terminal and two digital optical terminals.
To reproduce the digital sound, use the digital connection in
addition to the analog connection methods described on pages 7
to 9.
Digital coaxial cable (not supplied)
Digital optical cable (not supplied)
Turn off all components before making connections.
• When you connect other components, refer also to their
manuals.
When the component has a digital coaxial output
terminal, connect it to the 1(DVR/DVD) terminal,
using a digital coaxial cable (not supplied).
DIGITAL IN
1(DVR/DVD)
When the component has a digital optical output
terminal, connect it to the 2(DBS) or 3(VCR)
terminal, using a digital optical cable (not supplied).
Before connecting a digital
optical cable, unplug the
protective plug.
NOTES
• When shipped from the factory, the DIGITAL IN terminals have
been set for use with the following components:
– 1(DVR/DVD): For DVD recorder or DVD player
– 2(DBS): For DBS tuner
– 3(VCR): For VCR
If you connect other components, change the digital input
(DIGITAL IN) terminal setting correctly. See "Setting the digital
input (DIGITAL IN) terminals—DIGITAL IN 1/2/3" on page 20.
• Select the correct digital input mode. See "Selecting the analog
or digital input mode" on page 12.
• When you want to operate the connected component (except
DBS tuner) using the AV COMPU LINK remote control system
(see pages 32 and 33), connect them also as described on
pages 7 to 9.
10
2(DBS) 3(VCR)

USB connection

This receiver is equipped with a USB terminal on the front panel.
You can connect your PC to this terminal and enjoy sound
reproduced through your PC.
When you connect your PC for the first time, follow the procedure
below.
• Remember you cannot send any signal or data to your PC from
this receiver.
IMPORTANT:
Check if your PC equipped with the CD-ROM drive is running on
® ®
Windows 98 SE*, Windows Me*, Windows
XP* and prepare its CD-ROM.
How to install the USB drivers
The following procedure is described using the English version of
®
Windows XP. If your PC is running on a different version of
operation system or language, the screens shown on your PC's
monitor will differ from the ones used in the following procedure.
1. Turn on your PC and start running Windows
Windows ® Me, Windows ®
• If the PC has been turned on, quit all the applications now
running.
2. Turn on the receiver, and select the source as "USB."
3. Set the volume to minimum.
IMPORTANT:
Always set volume to "0" when connecting or disconnecting other
equipment.
4. Connect the unit to the PC using a USB cable (not
supplied).
USB
USB cable
(not supplied)
• Use "USB series A plug to B plug" cable when connecting.
®
2000*, or Windows
® 98 SE,
2000, or Windows ® XP.
PC
®