Selecting Installation Site - Daikin FAQ18PVJU Installation Manual

FOR THE FOLLOWING ITEMS, TAKE SPECIAL CARE DURING CONSTRUCTION AND
CHECK AFTER INSTALLATION IS FINISHED.
1. Items to be checked after completion of work
Items to be checked
Are the indoor and outdoor unit fi xed
fi rmly?
Is the gas leak test fi nished?
Is the unit fully insulated?
Does drainage fl ow smoothly?
Does the power supply voltage correspond
to that shown on the name plate?
Are wiring and piping correct?
Is the unit safely grounded?
Is wiring size according to specifi cations?
Is something blocking the air outlet or inlet
of either the indoor or outdoor units?
Are refrigerant piping length and additional
refrigerant charge noted down?
2. Items to be checked at time of delivery
* Also review the "SAFETY CONSIDERATIONS"
Items to be checked
Did you explain about operations while showing the operation manual to your customer?
Did you hand the operation manual over to your customer?
2-3 NOTE TO THE INSTALLER
Be sure to instruct customers how to properly operate the unit (especially cleaning fi lters, operating differ-
ent functions, and adjusting the temperature) by having them carry out operations themselves while looking
at the manual.
3.

SELECTING INSTALLATION SITE

(1) Select an installation site where the following conditions are fulfi lled and that meets with your
customer's approval.
• In the upper space (including the back of the ceiling) of the indoor unit where there is no possible
dripping of water from the refrigerant pipe, drain pipe, water pipe, etc.
• Where the wall is strong enough to bear the indoor unit weight.
• Where suffi cient clearance for installation and maintenance can be ensured.
(Refer to Fig. 1 and Fig. 2)
• Where optimum air distribution can be ensured.
• Where nothing blocks the air passage.
• Where condensate can be properly drained.
5
If not properly done, what is likely to occur
The units may drop, vibrate or make noise.
It may result in insuffi cient cooling.
Condensate water may drip.
Condensate water may drip.
The unit may malfunction or the
components burn out.
The unit may malfunction or the
components burn out.
It may be dangerous at electric leakage.
The unit may malfunction or the
components burn out.
It may result in insuffi cient cooling.
The refrigerant charge in the system is not
clear.
Check
Check
English