Hardware Setup - Western Digital WDH2Q40000 User Manual

Hardware Setup

4
1. Connect one end of the Ethernet cable into the Ethernet port located on the back
of the unit.
2. Connect the other end of the Ethernet cable directly into a router or network
switch port.
3. Plug the AC adapter into an electrical outlet.
4. Connect the other end of the adapter into the DC power supply socket located on
the back of the unit. The unit powers up automatically after approximately 30
seconds indicated by an LED illuminated on the outer ring.
Important: Wait for the drive to finish powering up (approximately three minutes)
before installing WD Anywhere Access.
AC adapter
Ethernet port
Power Port
MY BOOK WORLD EDITION
USER MANUAL
Router Port
Ethernet Cable
HARDWARE SETUP – 6