Power/Activity Led; Capacity Gauge; Rear View Ports - Western Digital WDH2Q40000 User Manual

Power/Activity LED

Appearance
Steady
Outer LED ring rotating clockwise
Alternate flashing between inner and outer LED rings
Rotating inner LED ring which increments as the
rebuild percentage increases
Simultaneous flashing of both inner and outer LED
rings

Capacity Gauge

The Capacity Gauge (inner LED) consists of six sections which illuminate in a
clockwise direction to indicate space used on the drive. Each section represents
approximately 1/6 (one sixth) of disk space. Because this drive is preformatted and
contains software and utilities, the first section is illuminated upon installation.

Rear View Ports

• Ethernet port —Connects to an open router, hub, or network switch port using an
Ethernet cable.
• USB 2.0 port —Connects an external USB hard drive.
• Power port —Connects to the supplied power adapter and cable.
Recovery Button
Pressing the recover button while powering up the device resets the admin user
name and password to default without erasing shared folders or volumes. The
recovery button also resets network configuration to DHCP.
Note: The default user name is admin and the default password is 123456 .
®
Kensington Security Slot
For drive security, this My Book device is equipped with a Kensington Security Slot,
which supports a standard Kensington security cable (sold separately). For more
information on the Kensington Security Slot and available products, visit
www.kensington.com.
MY BOOK WORLD EDITION
USER MANUAL
Description
Power-on state or power-
save mode
Device in use
RAID degraded mode.
See section 7 for drive
replacement instructions.
RAID rebuild mode
Device is overheating.
Shut down the My Book
device.
GETTING STARTED – 5