SB 10 Important Safety Instructions Important Safety Instructions Read these instructions. Keep these instructions. Heed all warnings. Follow all instructions. Do not use this apparatus near water. Clean only with a dry cloth. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
SB 10 Table of Contents INTRODUCTION DESCRIPTION AND FEATURES INCLUDED ITEMS SUBWOOFER REAR-PANEL CONTROLS AND CONNECTIONS SPEAKER PLACEMENT Placing the Soundbar on a Table Wall-Mounting the Soundbar Placing the Subwoofer CONNECTIONS Soundbar Connections Subwoofer Connections OPERATION Turning the Subwoofer On and Off...
Three speakers cables for the soundbar and a LFE/trigger cable for the subwoofer • The SB 10 soundbar contains the system’s left, center and right speakers. You can set the soundbar on a table in front of your TV. The system includes hardware that makes it easy to mount the soundbar on the wall next to a flat-panel TV.
One combination LFE/trigger cable One 200-watt subwoofer with 8" (200mm) low-frequency transducer Important: If anything is missing, or if any part of your SB 10 system fails to operate properly, contact your dealer immediately. Two wall-mount brackets for the SB 10 soundbar...
SB 10 Subwoofer Rear-Panel Controls and Connections Subwoofer Rear-Panel Controls and Connections Phase Switch Bass Boost Switch Power On Mode Switch Subwoofer Level Control Input Mode Switch External Trigger Input Connector Line Level In LFE Connector Line Level In L/R Connectors...
However, you are likely to hear the strongest bass reproduction when you place the subwoofer in a corner along the same wall as the soundbar. SB 10 Soundbar Subwoofer Listening Position If your TV is located in an entertainment or media center, you can mount the soundbar in a space directly above or below the TV.
Soundbar Connections Subwoofer Connections The SB 10 soundbar contains left-, center- and right-channel speakers that connect to your audio/video receiver or amplifier’s front left, center and front right speaker outputs. 1a If your receiver/processor has a dedicated subwoofer output with low-pass filtering (also called bass management), use the included LFE cable to connect the subwoofer’s Line Level LFE In jack to the dedicated subwoofer output (or LFE...
Page 9
SB 10 Connections 1b If your receiver/processor does not have a dedicated subwoofer output but does If you’re connecting to a receiver or preamp/processor with left and right line outputs have preamp-level (volume-controlled) line outputs, use the included LFE cable that are connected to front left and front right amplifier inputs, connect the single to connect one of those outputs to either of the subwoofer’s Line-Level L/R In...
SB 10 Operation Operation Turning the Subwoofer On and Off Subwoofer Adjustments: Phase Set the subwoofer’s Power Switch to the “On” position. This switch determines whether the subwoofer driver’s piston-like action moves in and out in phase with the soundbar speakers. If the subwoofer were to play out of phase with...
This unit is designed for trouble-free operation. Most problems users encounter are due to operating errors. So if you have a problem, first check this list for a possible solution. If the problem persists, consult your authorized harman kardon service center.