Harman Kardon SB 10 Owner's Manual page 9

SB 10
1b If your receiver/processor does not have a dedicated subwoofer output but does
have preamp-level (volume-controlled) line outputs, use the included LFE cable
to connect one of those outputs to either of the subwoofer's Line-Level L/R In
Connectors. Use an RCA cable (not supplied) to connect the other receiver or
preamp line output to the other subwoofer Line-Level L/R In connector. Set the
subwoofer's Input Mode switch to the "Normal" position.
LEFT LEFT
– + – + – +
FRONT SURROUND CENTER
– + – +
RIGHT RIGHT
Receiver or Processor
LFE Cable
(included)
Set Input Mode
Switch to "Normal"
To L/R
Inputs
PREAMP OUTPUT
LEFT RIGHT
To Preamp
Outputs
Mono RCA Cable
(not included)
Subwoofer
If you're connecting to a receiver or preamp/processor with left and right line outputs
that are connected to front left and front right amplifier inputs, connect the single
ends of Y-adapters (not supplied) to the receiver or processor's left and right line
outputs. Connect one of the Y-adapter's double ends to the subwoofer's Line Level L/R
In connectors, and connect the other double end to your amplifier's front left and front
right inputs. Set the subwoofer's Input Mode switch to the "Normal" position.
LEFT LEFT
– + – + –
FRONT SURROUND CENTER
– + – +
RIGHT RIGHT
Receiver or Processor
Stereo "Y" Cable
(not included)
LFE Cable
(included)
Mono RCA Cable
Set Input Mode
(not included)
Switch to "Normal"
To L/R
Inputs
2. After you have made and verified all other connections, plug the subwoofer's
Power cord into an active, unswitched AC outlet. DO NOT plug this cord into the
accessory outlets found on some audio components.
Connections
+
PREAMP OUTPUT MAIN AMP INPUT
LEFT RIGHT LEFT RIGHT
To Preamp
Outputs
Stereo Audio Cable
(not included)
Subwoofer
To Main Amp
Inputs
9