Do you have a question about the CoilMac 41 and is the answer not in the manual?
Questions and answers
Jennifer
May 28, 2025
Lever is hard to pull and push back up
1 comments:
Mr. Anderson
May 28, 2025
If the lever on the Akiles CoilMac 41 is hard to pull and push back up, the following steps can help resolve the issue:
1. Check for Obstructions: Make sure there is no debris, paper, or coil pieces jammed in the punching area or internal mechanism.
2. Lubricate Moving Parts: Apply a small amount of machine-safe lubricant to the lever joints and punching pins to reduce friction. Avoid over-lubrication.
3. Inspect Punching Pins: Ensure none of the punching pins are stuck or misaligned. Misaligned pins can cause resistance when moving the lever.
4. Check for Overloading: Do not exceed the maximum punching capacity. Punching too many sheets at once can strain the machine and make the lever harder to operate.
5. Tighten Loose Screws: Inspect the lever mechanism and surrounding hardware for loose screws or parts that might cause misalignment.
6. Contact Support if Needed: If the problem persists after these steps, professional service or replacement parts may be required.
Need help?
Do you have a question about the CoilMac 41 and is the answer not in the manual?
Questions and answers
Lever is hard to pull and push back up
If the lever on the Akiles CoilMac 41 is hard to pull and push back up, the following steps can help resolve the issue:
1. Check for Obstructions: Make sure there is no debris, paper, or coil pieces jammed in the punching area or internal mechanism.
2. Lubricate Moving Parts: Apply a small amount of machine-safe lubricant to the lever joints and punching pins to reduce friction. Avoid over-lubrication.
3. Inspect Punching Pins: Ensure none of the punching pins are stuck or misaligned. Misaligned pins can cause resistance when moving the lever.
4. Check for Overloading: Do not exceed the maximum punching capacity. Punching too many sheets at once can strain the machine and make the lever harder to operate.
5. Tighten Loose Screws: Inspect the lever mechanism and surrounding hardware for loose screws or parts that might cause misalignment.
6. Contact Support if Needed: If the problem persists after these steps, professional service or replacement parts may be required.
This answer is automatically generated