Denon DNP-F109 Owner's Manual page 16

n Add New Feature
• In order to add new functions, the environment and settings
required for connecting to broadband internet are needed
(vpage 8).
• Perform the add new feature operation after at least 2 minutes has
elapsed since turning this unit's power on.
1
SETUP
Press .
Turns on the Menu settings mode
and the Menu appears on the display
(vpage 10 "Menu map").
2
ui
Use to select "General"
– "Firmware" – "Add New
ENTER
Feature", then press or
p .
Display a list of the additional functions provided
Upgrade Status
by the upgrade.
Execute the upgrade process.
Upgrade Start
• If the upgrade is not successful, an error message identical to
those in "Update"(vpage 12) will appear on the display. Check
the settings and network environment, then update again.
The ID number shown on this screen is needed
Upgrade ID
when carrying out the procedure.
See the DENON website for details about updates.
When the procedure is complete, "Registered" is displayed and
updates can be carried out. If the procedure has not been carried out,
"Not Registered" is displayed.
Setting the general [General]
[Notes concerning use of "Update" and
"Add New Feature"]
• Do not turn off the power until updating or upgrading is completed.
• Even with a broadband connection to the Internet, approximately
20 minutes is required for the updating/upgrading procedure to be
completed.
• Once updating/upgrade starts, normal operations on this unit cannot
be performed until updating/upgrading is completed.
• Furthermore, updating/upgrading the firmware may reset the backup
data for the parameters, etc. set for this unit.
• If the update or upgrade fails, remove and re-insert the power cord.
"Update Retry" appears on the display and update restarts from
the point at which update failed. If the error continues despite this,
check the network environment.
• Information regarding the "Update" function and "Add New
Feature" will be announced on the DENON web site each time
related plans are defined.
• When usable new firmware is released with "Update" or "Add New
Feature", a notification message is displayed on the menu screen.
When you do not want to be notified, set "Notification" – "Update"
(vpage 12) and "Notification" – "Upgrade"
"Off".
13
(vpage 12) to