Preparing Your Projector - Mitsubishi Electric XL2550U User Manual

Preparing your projector

Checking accessories
The following accessories are provided with this projector. Check to be sure that all of the accessories are packed in
the package.
Cables
Audio/Video cable
(246C381-10)
Power supply parts
Power cord (two)
(246C483-10, 246C383-20)
Important:
• The attached power cords are to be used exclusively for this product. Never use them for other products.
1
2
Caution:
• Use of a battery of wrong type may cause explosion.
• Only Carbon-Zinc or Alkaline-Manganese Dioxide type batteries should be used.
• Dispose of used batteries according to your local regulations.
• Batteries may explode if misused. Do not recharge, disassemble, or dispose of them in fi re.
• Be sure to handle the batteries according to the instructions.
• Load the batteries with its positive (+) and negative (-) sides correctly oriented as indicated on the remote control.
• Keep batteries out of reach of children and pets.
• Remove the batteries, if the remote control is not used for a long time.
• Do not combine a new battery with an old one.
• If the solution of batteries comes in contact with your skin or clothes, rinse with water. If the solution comes in
contact with your eyes, rinse them with water and then consult your doctor.
USB 4 -pin
(type B)
USB 4 -pin
(type A)
USB cable
(246C509-10)
Remote control parts
Remote control
(290P136-10)
Inserting the batteries into the remote control
1. Remove the rear lid of the remote control.
2. Check the polarity (+), (-) of the batteries, and set them
3
3. Attach the rear lid.
Important:
• Use two size-AA batteries (R6P).
• Replace the 2 batteries with new ones when the remote
EN-6
Mini D-SUB
15-pin
Mini D-SUB
15-pin
RGB cable for PC
(246C521-10)
R6P (size-AA)
battery (two)
correctly, inserting their (-) side fi rst.
• If the battery is inserted from the (+) side fi rst, inserting
the (-) side is diffi cult because the coil spring end hits on
the battery side. If the battery is forced to insert in this
way, the outer label of the battery may get ripped and it
may cause a short-circuit and heating.
control is slow to operate.
D-SUB
9-pin
D-SUB
9-pin
RS-232C cable
(246C548-10)
• Used for projector control
by computer.
Others
• Lens cap (Attached to the
projector)
• Lamp replacement tray
( 857C106-10)
• CD-ROM (919C154-60)
• Safety Manual/
Quick Start up (871D489-60)