Error Indicators And Warnings; Maintenance; Specifications - Sharp HT-CN300H Operation Manual

Error indicators and warnings

HT-CN300H
When you load an unplayable disc or fail to perform operations properly, the following
messages are displayed on the unit and the TV screen.
Display
(*): Should the same message appear even if the unit is unplugged and plugged in or
is set to the stand-by mode and on again, contact your local dealer where you pur-
chased the unit.

Maintenance

Cleaning the cabinet
Periodically wipe the cabinet with a soft cloth and a diluted soap solution, then with a
dry cloth.
Do not use chemicals for cleaning (petrol, paint thinner, etc.). It may damage the
cabinet finish.
Do not apply oil to the inside of the unit. It may cause malfunctions.
42
Meaning
The surround system does not operate properly.
Place the unit away from noise source or plug the
AC power lead to another AC socket. (*)
The amplifier is defective or the surround system
does not operate properly.
Place the unit away from noise source or plug the
AC power lead to another AC socket. (*)

Specifications

As part of our policy of continuous improvement, SHARP reserves the right to make
design and specification changes for product improvement without prior notice. The
performance specification figures indicated are nominal values of production units.
There may be some deviations from these values in individual units.
General
Power source AC 230 V, 50 Hz
Power consumption Power on: 195 W
Power stand-by: 0.5 W (*)
Dimensions Width: 230 mm (9-1/8")
Height: 377 mm (14-7/8")
Depth: 400 mm (15-3/4")
Weight 11.5 kg (25.4 lbs.)
Terminals Front speakers, Centre speaker and Surround speakers:
6 ohms
Monitor output: S-video/video
Video output (Video 1): RCA type
Audio output (Video 1): RCA type (L/R)
Video input (Video 1): RCA type
Audio input (Video 1): RCA type (L/R)
Audio input (Auxiliary): RCA type (L/R)
Video input (Video 2): RCA type
S-video input (DVD): S-terminal
Video input (DVD): RCA type
Audio input (Video 2): RCA type (L/R)
Digital input (DVD): Optical
Digital input (DVD): Coaxial
( * ) This power consumption value is obtained when the demonstration mode is
cancelled in the power stand-by mode. Refer to page 13 to cancel the dem-
onstration mode.
02/6/17 HT-CN300H_(E)5.fm