Connection To A Pc; Connection To An Applicable Transceiver (Quick Data Transfer) - Kenwood TS-990S Instruction Manual

CONNECTION TO A PC

The transceiver can be connected to a PC using a USB cable or an RS-232C straight-through cable.
Note:
◆ Turn the transceiver and your PC OFF prior to connecting your PC to the transceiver using the cable.
◆ Use the commercial available USB cable or RS-232C straight-through (not "crossed") cable.
◆ In principle, using the USB audio results in a delay. Additionally, audio interruptions may occur depending on the characteristics of your PC and
the status of the load. Use USB audio for communications where time lag is inconsequential or for recording received audio in the PC.
◆ To control the transceiver via the USB connector using a PC, you need to install the virtual COM port driver onto the PC.
◆ To use the USB audio, the driver available in your PC as standard will be used. You can down load the ARUA-10 USB Audio Controller from the
KENWOOD web site.
PC

CONNECTION TO AN APPLICABLE TRANSCEIVER (QUICK DATA TRANSFER)

For data transfer, use an RS-232C cross-cable (female to female) to connect the transceiver COM connector to the
COM connector of the secondary transceiver.
You can connect this transceiver to the following applicable transceivers:
• TS-990 series • TS-590 series • TS-480 series • TS-2000 series • TS-570 series
TS-990S
Contents Index
To RS-232C Serial
Port
To USB
port
{page 16-26}
(female)
INSTALLING AND CONNECTING THE TRANSCEIVER 1
RS-232C Straight Cable
TS-990S
USB cable
RS-232C Cross Cable
Applicable Transceiver
(female)
USB (B) Connector
(female)
1-5