Kenwood RXD-355 Service Manual page 7

DISASSEMBLY FOR REPAIR
How to remove the belt (TAPE 2) (See Fig. 10-4)
1. Remove the main belt (E1) x 1 pc., from the motor side.
2. Remove the FF/REW belt (E2) x 1 pc.
How to remove the motor (See Fig. 10-5)
1. Remove the screws (F1) x 2 pcs., to remove the motor.
Motor
FF/REW
TAPE2
Belt
(E2)x1
Main Belt
Figure 10-4
CD MECHANISM SECTION
Perform steps 1, 2, 3, 11 and 14 of the disassembly method
to remove the CD mechanism.
How to remove the loading motor
(See Fig. 11-1)
1. Bend the hooks (A1) x 5 pcs., to remove the loading motor.
How to remove the pickup (See Fig. 11-2)
1. Remove the stop washer (B1) x 1 pc., to remove the gear
(B2).
2. Remove the screws (B3) x 2 pcs., to remove the shaft (B4).
3. Remove the pickup.
Note
After removing the connector for the optical pickup from the
connector wrap the conductive aluminium foil around the front
end of connector so as to protect the optical pickup from
electrostatic damage.
Motor
(F1) x2
Ø2.6x5mm
TAPE1
Main Belt
TAPE2
(D1)x1
Main Belt
(E1)x1
TAPE1
FF/REW
Belt
(D2)x1
(B3) x2
ø2.6 x6mm
RXD-355
Figure 10-5
(A1)x2
Figure 11-1
Stop Washer
(B1) x1
Shaft
Gear
(B4) x1
(B2) x1
Figure 11-2
Motor
Loading Moter
(A1)x1
(A1)x2
CD Base
Pickup
CD Mechanism
7