Advertisement
Quick Links
Advertisement
Related Manuals for Edimax EN-9220F-64
Summary of Contents for Edimax EN-9220F-64
- Page 1 64/32bit 66/33MHz PCI Gigabit Adapter EN-9220F-64 User’s Manual...
-
Page 2: Fcc Compliance Statement
FCC COMPLIANCE STATEMENT This equipment has been tested and found to comply with the limits of a Class B computing devices, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful... - Page 3 Introduction Thanks you for purchasing our Gigabit Fast Ethernet Adapter. This guide is to provide the installation and usage of this adapter for network installers and users. The Gigabit network adapter complies to 32/64 bit PCI specification and supports full duplex feature which can double network speed.
- Page 4 Features & Specifications (1) Features & Benefits Supports 64/32-bit, 66/33MHz PCI Bus Master for high performance and low processor utilization. Complies with the IEEE 802.3z standard. Full duplex design to double the performance to 2000Mbps. One Fiber SC connector for 1000Mbps network speed. •...
- Page 5 (2) Technical Specification Connector : Fiber SC × 1 Standard : IEEE 802.3z Transmission Rate : 1000Mbps / 2000Mbps Hardware Required : IBM compatible PC with available PCI slot ( PCI 2.1/2.2 ),66/33MHz, 32bit & 64bit IRQ Line : Assigned by system I/O Address : Assigned by system Drivers...
-
Page 6: Hardware Installation
Installation (1) Hardware Installation To insert the network adapter into your PC, follow the steps bellow : 1. Turn off the computer and remove its cover. 2. Insert the adapter into a PCI slot. 3. Secure this adapter to the rear of the computer chassis and put back the computer cover. -
Page 7: Full Duplex
Trouble-shooting If you experience any problems with the adapter, first make sure the appropriate driver is loaded, the proper cable is connected to the adapter port and the hub/switch complies with the adapter specification, such as 1000BaseFX, then check the LED. The adapter provides two LEDs to indicate network status. - Page 8 TRADEMARKS Copyright 2001/2002 by the manufacturer of this product. No part of this manual may be reproduced, transcribed, stored in a retrieval system, translated into any language or computer language without the prior written consent of the manufacturer. All brand and product names are trademarks and/or registered trademarks of their respective companies.