Wel-Bilt M141300A Owner's Manual page 26

8. Reinsert the filter and refill the reservoir tank with 1 gallon (4L) of hydraulic oil.
9. Dispose of used oil at an oil-recycling center. Used hydraulic oil is hazardous waste.
10. Extend and retract push plate 5 (five) times to purge air from the system.
11. Check hydraulic oil level and fill if necessary.
Change hydraulic inlet filter every 50 hours of operation.
3. Change filter
4. Lubricate 1. Lubricate the beam before each use with engine oil. Lubricate the top of the
2. If necessary, adjust the side bolts so the push plate moves freely. There should
5. Hose clamps Check before each use if the hose clamps on the suction hose (attached to the side of
the pump) are tight. Check the hose clamps on the return hose at least once a
season.
If the engine is equipped with a spark arrestor muffler, clean and inspect it regularly
6. Spark arrestor
(follow manufacturer's service instructions). Replace if damaged.
muffler
Periodic Maintenance
Maintain oil level with the range specified on the dipstick at all times.
beam and under the top edge so the push plate will easily move across the beam.
be no excess space between the push plate and beam.
26