Step One: Inspection/Maintenance - Wel-Bilt M141300A Owner's Manual

Step One: Inspect and maintain log splitter before each use
If the log splitter has been used previously, it must be inspected and maintained BEFORE EACH SUBSEQUENT USE.
ALWAYS shut off the engine, disconnect the spark plug, and relieve system pressure before
inspecting, cleaning, adjusting, or repairing the splitter. Relieve system pressure by moving Split
Control Lever back and forth several times.
IMPORTANT:
If a part needs replacement, only use parts that meet the manufacturer's specifications. Replacement parts that do not meet
specifications may result in a safety hazard or poor operation of the log splitter.
1. Engine off / Perform all inspections/repairs with the engine off and hydraulic system pressure relieved.
relieve pressure
2. Remove debris Remove debris from engine, muffler, and moving parts.
3. Fuel tank / lines Check fuel tank and fuel lines for leaks.
Any fuel leak is a fire hazard. Fix any fuel leaks before starting engine.
4. Mechanical parts Check to be sure that all nuts and bolts are tight to make sure the log splitter is in safe
working condition.
Lubricate the beam area with engine oil before and after each use where push plate slides.
DO NOT use grease to lubricate. Make sure to lubricate both front and back of the beam face.
can cause bodily harm if ejected.
Before Each Use-Inspection / Maintenance
Make sure engine is off and cool.
1.
2. Disconnect the spark plug
Relieve all hydraulic system pressure by moving the Split Control Lever back and forth
3.
several times.
1. Engine debris. Debris on a hot engine can be a fire hazard. Clean debris and chaff from
engine cylinder head, cylinder head fins, blower housing rotating screen, and muffler
areas. Avoid contact with hot muffler.
2. Other debris. Debris on moving parts can cause excess wear. Clear debris from the slide
beam, wedge, and push plate.
WARNING:
NEVER disassemble the spring tubes. The internal springs are powerful and
WARNING
15