Step Three: Work Site Selection & Set-Up - Wel-Bilt M141300A Owner's Manual

Before Each Use – Work Site Selection and Set-up
Step Three: Work site selection and log splitter set-up
It is important to select an appropriate work site and properly set up the log splitter in order to
minimize the risk of slips and falls, equipment rolling or tipping over, carbon monoxide poisoning,
and accidental fires.
1. Select location
Fire precautions
2.
.
3 Position splitter 7'
from any
combustibles or
flammable liquids
4. Block wheels
5. Lubricate beam
Select an appropriate location for operating the log splitter.
Requirements:
1. Dry-level surface with good footing. Stay clear of areas with mud, ice, tall grass, weeds,
brush, or snow.
2. Outdoors, away from air intakes.
WARNING:
The running engine gives off carbon monoxide, a poisonous gas that can
kill you. You CANNOT smell it, see it, or taste it.

ONLY run log splitter OUTDOORS and away from air intakes. NEVER run log splitter
inside homes, garages, sheds, or other buildings or semi-enclosed spaces. These spaces can
trap poisonous gases, EVEN if you run a fan or open windows.

If you start to feel sick, dizzy, or weak while using the log splitter, shut off the engine and
get to fresh air RIGHT AWAY. See a doctor. You may have carbon monoxide poisoning.
Take the following precautions against fire:
1. IMPORTANT: If your splitter will be used near any unimproved forest, brush, or
grassy covered land, then engine must be equipped with a spark arrestor.
(See the "Specifications" section of this manual to determine if your splitter already has a
spark arrestor. Contact Wel-Bilt Product Support at 1-877-234-6869 for information about
obtaining a spark arrestor for your log splitter if it is unequipped.)
2. Make sure you comply with applicable local, state and federal codes.
3. Keep a fire extinguisher available (classified for both ordinary combustibles & flammable
liquids) as a precautionary measure when operating the log splitter in dry areas.
Position muffler at least 7 ft. from combustible objects during operation.
Hot exhaust fumes from engine could cause fire. Also, hydraulic oil leaking or spraying on hot
engine can ignite.
Block the wheels to prevent unintended movement of the log splitter.
Lubricate the beam area before and after each use where push plate slides. DO NOT use
grease to lubricate. Make sure to lubricate both front and back of the beam face.
WARNING
18