Kenmore 253.4475 Series Use & Care Manual page 17

Connecting Water Supply To Freezer
Plastic Water Tubing
to Ice Maker
Fill Tube
Figure B. Stainless Steel Water Line Connection
5. With steel clamp and screw, secure water supply
line (copper tubing only) to rear panel of freezer as
shown.
6. Coil excess water supply line (copper tubing only),
about 2½ turns, behind freezer as shown and
arrange coils so they do not vibrate or wear against
any other surface.
7. Turn ON water supply at shutoff valve and tighten
any connections that leak.
8. Reconnect freezer to electrical power source.
9. To turn ice maker on, lower wire signal arm (side
mounted) or set the ice maker's On/Off power
switch to the "I" position (rear mounted).
NOTE
Check with your local building authority for
recommendations on water lines and associated
materials prior to installing your new freezer.
Steel
Clamp
Stainless
Steel
Waterline
Water Valve
Bracket
Valve Inlet
Water Valve
6 ft. Stainless Steel Water Line
From Household Water Supply
17