The Remote Control Does Not Work; I Want To Change The Language For Messages And Menus; The Authentication Setting Of Wireless Lan Fails; The Remote Control Does Not Work S - Epson EB-1410Wi User Manual

Problem Solving

The remote control does not work

Check
Is the remote control light-emitting area pointing towards the
remote receiver on the projector during operation?
Is the remote control too far from the projector?
Is direct sunlight or strong light from fluorescent lamps shining onto
the remote receiver?
Is the correct setting for the Remote Receiver selected?
Are the batteries dead or have the batteries been inserted in the
wrong direction?

I want to change the language for messages and menus

Check
Change the language setting.

The authentication setting of wireless LAN fails

Check
Is the time set correctly?
Point the remote control towards the remote receiver during operation.
s "Remote control operating range"
The operating range for the remote control is about 6 m.
s "Remote control operating range"
Set the projector up in a location where strong light does not shine onto the remote receiver. Or set the remote receiver to
Off from Remote Receiver in the Configuration menu.
s Settings - Remote Receiver p.142
Check the Remote Receiver from the Configuration menu.
s Settings - Remote Receiver p.142
Insert new batteries in the correct direction.
s "Replacing the remote control batteries"
Adjust the Language setting from the Configuration menu.
s Extended - Language p.144
If the wireless LAN is set correctly but the authentication setting fails, the time may not be set correctly. Check
if it is set correctly.
s Extended - Time/Schedule Settings
Remedy
p.20
p.20
p.19
Remedy
Remedy
p.144
183