Cleaning The Lint Filter - Asko T761 Quick Start Manual

QUICK START PROCEDURES
1. Press the Power button to turn on the machine.
2. Load the dryer.
3. Check the lint filter. Clean it, if needed.
4. Check that the door is clear of laundry then close it firmly. (The door won’t shut if it’s slammed.)
5. Press the button for the desired program (P1–P4).
6. Press Start. The machine will start.
UNDERSTANDING THE LCD WINDOW
The LCD window is easy to read and understand. The illustration below explains what each item on the LCD window is.
Program
When you press the Power button,
the display toggles between the
program numbers and the wash
program names, (e.g., Extra Dry,
Dry, etc.)
Preset Programs
Displays the program that
is selected/running.
The LCD window also displays the menus and options available when you customize the preset programs. Refer to your Use and Care
Guide for more details.

CLEANING THE LINT FILTER

Although the lint in your ASKO dryer will be minimal, the lint filter should be cleaned after each load
to ensure maximum air flow and prevent possible overheating. To clean the filter, follow the steps
below:
1. Grasp the handle and pull it toward you.
2. Remove the filter from the holder by pulling it up.
3. Open the filter and gently brush away any lint.
4. Fold the filter together and return it to the holder on the door.
5. Push the holder in until it snaps into place.
We recommend that you clean the lint filter after every load.
NOTE:
EMPTYING THE CONDENSATION WATER CONTAINER
If Model T781 is not installed to pump out the condensed water into a drain or a sink, you should empty the
water container every three to five dryer loads, depending on the spin speed you use when you wash the
clothes. For example, clothes spun at 800 rpm will have more moisture when you take them out of the
washer than clothes spun at 1400 rpm. Therefore, the dryer will have to remove more water.
To empty the container, simply pull it out and pour out the water. This water is clean and can be used to water
plants.
If the container becomes too full, the machine will shut down. To restart the program, empty the container and
press Start. It may be a few minutes before the machine starts because it drains the excess water from the sump before it restarts.
OVERHEATING PROTECTION
The dryer has a protection device that shuts the machine off if the temperature becomes too high. Overheating could occur if the lint filter is
clogged or if the fan or condenser unit (Model T781) needs to be cleaned. If the dryer shuts off during a program on Model T781, first, make
sure the condensation water container is empty. If that isn’t the problem, check the lint filter. Lastly, it could be the fan or condenser unit needs
to be cleaned. See your Use and Care Guide for instructions on how to clean these items.
Start
Indicates that you pressed Start
and the program is running.
NOTE: Do not remove the water container while the machine is running.
Program Time
When you start a program, the total time the
program runs is displayed. As the program
progresses, the time remaining displays. The
program time toggles between minutes (e.g.,
23) and hours (e.g., 1h).
Stop
Indicates that the program has ended
or that you pressed Stop.
T761/T781
(T781 only)
Art. No. 80 646 44 Rev. 02