GE 36" Owner's Manual page 17

Anti-tip
Install Wall Toggles:
bracket
The wall toggles and bolts can be ordered
installation
are installed in the drywall and metal studs
(cont.)
for stability. Install the wall toggles as follows:
• Drill 1/2" holes at the wall markings made
• Hold the metal channel flat against the plastic
• Gently pull back at the ends of the plastic
• Hold the ends of the straps in one hand
• Place your thumb between the plastic straps
Install Screws and Bolts:
• Have someone hold the wall bracket centered
• Insert the lag screws through the bracket
• Insert the bolts into the toggle by hand until
in the holes at the ends of the wall bracket.
straps and slide the channel through the hole.
straps to make the channel rest flush behind
the wall.
and slide the plastic cap along the straps until
the flange of the cap is flush with the wall.
and bend up and down to snap the straps off
at the wall.
in place with each of the holes aligned with
the correct opening in the bracket and level
with the horizontal line.
and into the stud. Tighten with a wrench.
snug. Tighten with a wrench.
Anti-Tip Bracket Installation
36" All-Refrigerator and All-Freezer Units
Plastic Straps
Metal Channel
Cap
Lag Screw
Anti-Tip Wall Bracket
Drywall or
Steel Stud
Bolt
Anti-Tip Wall Bracket
Wood Stud
Wall Toggle
17