GE 36" Owner's Manual page 20

Secure unit
• The "L" rods can be found in the upper left
to wall
• There are 2 washers and a hair pin cotter per
• Rotate and move the "L" rod into the slot
• Pull out on the end of the rod to make sure
• Locate the hole on the rod that is closest
• Align the straight section of the pin with
• Check the rod for tightness by pulling forward.
• Replace the grille panel.
20
and right corners of the unit in the access
compartment. Look through the access
compartment to make sure the rods line
up with the anti-tip bracket.
rod. Remove the washers and hair pin cotter
from the end of the rod.
the slot, rotate the "L" rod so the hook portion
is pointing down. The holes at the front end
of the rod should be in a vertical position.
Do this to both sides.
it is secure in the bracket.
to the unit. A hair pin cotter will be put through
this hole to secure the rod. If this hole appears
to be too far away for a snug fit against
the unit, add the washers one at a time until
the pin will fit tightly into the hole.
the hole from the underside of the rod. Push
the pin up until it snaps into position. Pliers
may be used. NOTE: The hair pin cotter must be
vertical when this step is completed to ensure
the "L" rod is engaged in the bracket.
If the rod moves, remove the hair pin cotter
and place another washer on the rod.
Reinsert the pin.
Anti-Tip Bracket Installation
36" All-Refrigerator and All-Freezer Units