FujiFilm 3000 User Manual page 36

No Description
7
Tone of the images cannot be
reproduced in darker areas.
8
The printed poster does
not appear.
9
The printer does not start to print
even after the START/STOP key
has been pressed.
10
Spots or marks appear in
the margin area.
11
A document jam occurs.
12
The printing process is
unexpectedly slow.
(A "SLOW MODE" message
will appear on the display.)
13
A black band appears on
the back of the print.
14
The printer makes a rattling
or grating noise, or the
"SHUTTLE ERROR" message
appears on the display.
15
The ink sheet (Thermal Transfer
Paper, HDP Paper) has a lot
of wrinkles in it.
16
White bubbles appear on
the printed surface (Thermal
Transfer Paper, HDP Paper).
17
The poster is printed as a mirror
image of the original.
18
Low contrast on the
message display.
34 Troubleshooting
Remedy
Set the contrast level to lighter position
to reduce the density.
If the images on the original are too dark,
change to a better copy of the original
where possible.
Check that the type of paper indicated on
the message display matches the type actually
being used.
Open the cover of the printer and check
to see if the paper is caught in the paper
feed rollers.
Check that the printer cover
is closed properly.
Place the original into the document bay
until it stops.
The printer will not scan transparent documents.
Make a copy on plain paper and restart
the process.
Check to see if an error message appears on
the message display.
Clean the thermal heads.
Clean the platen glass in
the scanner unit.
Open the scanner cover and remove the original.
Check that the scanner cover is closed properly.
If a document jam occurs again, check that
the original has been set properly.
The printer automatically switches to a lower
speed when the thermal heads overheat. This
typically occurs when printing posters with large
black areas or when printing in reverse mode.
This is normal, and does not indicate an error
in the printing process.
A black band is printed on the Direct
Thermal Paper, to indicate that the paper
roll is nearly finished. Change the paper roll
when the band appears.
Clean the shuttle shaft.
Remove the packaging material
in the shuttle shaft unit.
Check that the type of paper indicated on
the message display matches the type actually
being used.
Check that the type of paper indicated on
the message display matches the type actually
being used.
Change the setting in function mode
("IMAGE DIRECTION") to "NORMAL".
Remove the protective covering on
the control panel.
Ref.
p 14
p 13
p 15
p 18
p 32
p 35/36
p 36
p 18
p 18
p 20
p 35
p 3
p 13
p 13
p 25
p 12