Sharp CD-CH1000 Service Manual page 15

145
146
147
110
111
Direct the recess part
(trapezoidal side) of the axis
135 in this direction.
Scale: 2 magnifications
124
129
126
123
125
127
138
137
134
TRAY DRIVE GEAR R
136
TRAY JOINT GEAR R
TRAY BIG GEAR SET POSITION
*2
*1
134
TRAY DRIVE GEAR R
136
TRAY JOINT GEAR R
129
123
131
Scale: 2 magnifications
M T SW PWB
*1: To position the axis part of 136, engage it with 138.
*2: When it is aligned as described in *1, the hatched part
(low gear-height part of gear) will be positioned in this position.
Note: After positioning the tray big gear in the set position, engage these gears.
133
TRAY GEAR B
Figure 15
– 15 –
CD-CH1000
Mark position
* This position becomes the
reference (stock) position
of the tray.
132
TRAY GEAR A
The hole must align.
It must not rotate in contact
with the peripheral (hatched)
part of 131.
133
TRAY GEAR B
133
The hole must align.
After assembling 132,
assemble 133.
132
TRAY GEAR A
132