Modifying The Temperature; Modifying The Fan Speed; Using The Air Swing Feature - Whirlpool Cool Impression room air conditioners Owner's Manual

---"--.-m.-I.O--- -m--"----1.-~---~
Modifying the 8: ~~~~~pr~raturs
Although the AUTO COOL Cycle has an
initial factory-preset cooling temperature,
you may decide the room is too cool or too
warm. When you change the temperature
from the factory-preset, the air conditioner
uses fuzzy logic (computerized "learning") to
remember your preferences. Over time, the
unit "learns" exactly what conditions make
you most comfortable.
To modify the temperature:
l
Press the WARMER Button to raise the
temperature of the outgoing air.
l
Press the COOLER Button to lower the
temperature of the incoming air.
NOTE: Each press alters the temperature
approximately 1°C.
Modifying the fan speed
Although the AUTO COOL Cycle automati-
cally chooses the proper fan speed to cool
the room, you may desire to increase or
decrease the amount of air blowing into
the room.
To modify the fan speed:
*Press the FAN SPEED Button.
NOTE: Each press of the FAN SPEED
Button advances the fan speed through
the cycle:
0
FAN SPEED
HI+MED+LOW'HI
Using the AIR SWING feature
The AIR SWING feature tells your air
conditioner to move the air output louvers
side to side and swing the cooled air through
the room.
To activate the AIR SWING feature:
aPress the AIR SWING Button.
(yiir-)
To deactivate the AIR SWING feature:
l
Press the AIR SWING Button again.