Baby Lock Tiara II BLTR16-2 Instruction And Reference Manual page 29

Diagnostics
Motor Speed Sensor Test
Remove bobbin case and top thread.
Clear all objects from the needle area.
Press Start/Stop on Handle.
Passing Test:
The value stabilizes at 100.
Back
Diagnostics
Foot Pedal Test
Remove bobbin case and top thread.
Clear all objects from the needle area.
Depress foot pedal completely.
Passing Test:
Value below varies from 0 to 100%.
Back
Solid beep for 1/3 of a stitch cycle,
System Information
no beep for the rest of the cycle.
Serial Number
Type
C-Pod
Display
Stitch Counters
Lifetime
Trip
Reset
Back
Figure 40
Page 28
0
Main
Figure 38
45%
Main
Figure 39
HA010553310
Board
Firmware
2.02 3.04
1.00 2.00
000004361
000004361
Main
Motor Speed Sensor Test
The "Speed" Sensor test can help you determine whether
or not there is a problem with the Baby Lock Tiara II
speed sensor. Before performing this test, remove the
bobbin case and the top thread. Press the foot pedal so
that the machine will begin slowly rotating. The white box
will show a number that should stabilize at 100 if the sen-
sor is functioning properly. Release the foot pedal to stop
the ma chine (Figure 38).
Press the "Main" button to return to the "Main" menu
screen or the "Back" button to return to the "More" menu
screen.
Pedal Test
The "Pedal" test can help you determine if there is a prob-
lem with the Baby Lock Tiara II foot pedal. As you slowly
depress the foot pedal a percent of depression will appear
in the white box. The foot pedal should be controllable
from 0 to 100% (Figure 39).
Press the "Main" button to return to the "Main" menu
screen or the "Back" button to return to the "More" menu
screen.
System Information Screen
The serial number of the machine is displayed at the top
of the System Information screen. This number matches
the one found on the label at back of machine..
Information contained in the white boxes below the serial
number identifies the electronics board version numbers
as well as the firmware version numbers of the Baby Lock
Tiara II and its handlebars.
The Lifetime and Trip (or project) stitch counters count
the number of stitches the machine has performed. The
Lifetime count is the total number of sewn stitches since
the machine was built. The Trip Counter can be reset to
keep track of the number of sewn stitches during a given
project. To reset this counter, press the blue "Reset" but-
ton found aligned with the Trip counter.
The Lifetime counter cannot be reset and should be used
as an indicator to determine when general machine main-
tenance should be performed by your authorized Baby
Lock retailer (Figure 40).
Press the "Main" button to return to the "Main" menu
screen or the "Back" button to return to the "More" menu
screen.
Baby Lock Tiara II Instruction Manual