Important Safety Warnings - HP Invent zx2000 Getting Started Manual

Important Safety Warnings

Å
Å
Å
Å
WARNING: Avoiding Electrical Shocks. To avoid electrical shock, do not
open the power supplies. There are no user-serviceable parts inside.
To avoid electrical shock and harm to your eyes by laser light, do not
open the DVD laser module. The laser module should be serviced by
service personnel only. Do not attempt to make any adjustment to the laser
unit. Refer to the label on the DVD for power requirements and
wavelength. This product is a class I laser product.
WARNING: Removing and Replacing the Cover. For your safety, never
remove the system side cover without first disconnecting the power cord
from the power outlet and removing any connection to a
telecommunications network. If a Power Protection Device is fitted to your
system, you must shut down your computer using its on/off switch, then
remove the power cord before removing the system's side cover. Remove
the Power Protection Device cables before any servicing operation. Always
replace the side cover before switching the system on again.
WARNING: Battery Safety Information. There is a danger of explosion if
the battery is incorrectly installed. For your safety, never attempt to
recharge, disassemble, or burn an old battery. Replace the battery with
the same or equivalent type, as recommended by the manufacturer.
The battery in this system is a lithium battery that does not contain any
heavy metals. However, to protect the environment, do not dispose of
batteries in household waste. Return used batteries either to the shop from
which you bought them, to the dealer from whom you purchased your
system, or to HP so that they can either be recycled or disposed of in the
correct way. Returned batteries will be accepted free of charge.
WARNING: Avoiding Burn Injuries. Some parts inside the computer will
be hot. Wait approximately three to five minutes for them to cool down
before touching them.