Download Print this page

Extron electronics RGB 160xi Setup Manual page 2

Extron interfaces setup guide
Hide thumbs Also See for RGB 160xi:

Advertisement

Setup Guide — RGB 160xi and RGB 164xi (cont'd)
100-240V
0.5 A MAX
GAIN/
PEAK
100%
UNITY
50%
50-60Hz
8
9
N
This figure shows the RGB 164xi rear panel. The features of the RGB 160xi rear panel are
similar except there is no Output 2 (
Step 7 — Connect video output(s)
Connect the RGBHV, RGBS, or RGsB video displays to Output 1 (
if required, Output 2 (
right.
Step 8 — Connect audio output
Connect an audio device to the five-pole, 3.5 mm captive screw connector
m
(
). Follow the wiring diagram below for unbalanced or balanced stereo
output.
Tip
NO GROUND HERE.
Sleeve(s)
Tip
NO GROUND HERE.
Unbalanced Stereo Output
CAUTION
Step 9 — Connect power
Connect a standard IEC AC power connector (100-240 VAC, 50-60 Hz) to this socket (
Power on input and output devices.
Step 10 — Set rear panel DIP switches
The first three rear panel DIP switches (
Sync on Green (SOG) — Set to on (up) for RGsB output; set to off for RGBHV or
RGBS output.
Digital Display Sync Processing (DDSP
(up) for no sync processing (may be needed for some LCD and DLP plasma displays) .
Serration Pulses — Set to on (up) to keep serration pulses; set to off to remove them. If there is
flagging or bending at the top of the video image, set this switch to off.
N
Turning on the DDSP switch disables the horizontal shift.
Step 11 — Set rear panel Gain/Peak switch
This rear panel switch (
peaking, gain with 100% peaking. For cable runs of 125 feet or less, use the Unity setting.
Step 12 — Set front panel DIP switches
These front panel ID bit termination DIP switches (
laptop and no local monitor. Both switches must be set to off if using a local monitor.
Step 13 — Adjust horizontal shift
This front panel knob (
Extron USA - West
Extron USA - East
Headquarters
+800.633.9876
+800.633.9876
Inside USA / Canada Only
Inside USA / Canada Only
+1.919.863.1794
+1.714.491.1500
+1.919.863.1797 FAX
+1.714.491.1517 FAX
R
G
H
V
OUTPUT 1
11
10
l
— RGB 164xi only), as shown in the figure at
Left
Right
For unbalanced audio, connect the sleeve(s) to the center contact ground.
DO NOT
connect the sleeve(s) to the negative (-) contacts.
i
) can be set to Unity (no gain and no peaking), gain with 50%
f
) adjusts the horizontal shift of the remote output display device(s).
Extron Europe
Extron Asia
+800.3987.6673
+800.7339.8766
Inside Europe Only
Inside Asia Only
+31.33.453.4040
+65.6383.4400
+31.33.453.4050 FAX
+65.6383.4664 FAX
© 2010 Extron Electronics. All rights reserved.
B
R
S
H
AUDIO
L
R
OUTPUT 2
13
l
).
Tip
Ring
Sleeve(s)
Tip
Ring
Balanced Stereo Output
j
) control:
) — Set to off (down) for sync processing; set to on
d
) must both be set to on (up) if using a
Extron Japan
+81.3.3511.7655
+81.3.3511.7656 FAX
G
B
V
S
12
RGBHV
Video
k
) and,
RGBS
Video
RGsB
Video
Left
Right
Extron China
Extron Middle East
+400.883.1568
+971.4.2991800
Inside China Only
+971.4.2991880 FAX
+86.21.3760.1568
+86.21.3760.1566 FAX
R
G
B
H
V
S
R
G
B
H
V
S
R
G
B
H
V
S
i
).
68-549-50
Rev. A
02 10

Advertisement

loading

This manual is also suitable for:

Rgb 164xi