Vacuum Mode - Shark VAC-OR-STEAM MV3010 Owner's Manual

Vacuum Mode

Fig. 6
Carpet
USING VACUUM MODE
1 When the vacuum nozzle head is firmly in place,
twist the quick release cord holder to unwrap
the power cord completely. Plug in the unit. The
carpet light (on the left hand side of the floor
nozzle when standing behind the unit) will begin
to blink blue. (Fig. 5) The vacuum is in standby
mode.
2 To begin vacuuming, step on the foot pedal and
the carpet light on the vacuum nozzle will be
solid blue. (Fig. 6) Place your foot lightly on the
top of the vacuum nozzle and tilt the handle
back to begin vacuuming.
To switch to vacuuming in bare floor mode, step
on the pedal once more. The bare floor light will
now be solid blue. (Fig. 7)
To return to standby mode, step on the pedal
once more.
NOTE: If the unit is jammed both bare floor
and carpet lights will begin to blink blue. Please
reference the troubleshooting guide for more
information.
QUICK TIP: The vacuum can be switched
from carpet to bare floor mode while actively
vacuuming or while the unit is at rest. Switching
to bare floor mode will disengage the brush roll.
4 TOLL FREE: 1-800-798-7398
MV3010_40_ENG_IB_120703_1.indd 4
Fig. 5
Fig. 7
Bare floor
1
2
3
Fig. 9
Fig. 8
USING THE ACCESSORIES
To use the crevice tool or the dusting brush:
Remove the accessory hose from the back of the
unit by turning the hose to the left or right to
unlock. (Fig. 8)
Insert the crevice/brush combo tool onto the end
of the hose. (Fig. 9) To use it as a crevice tool,
press the latch on the crevice nozzle and slide
the brush down to expose the crevice nozzle.
To replace the accessory hose back into the
vacuum, remove the accessories and insert the
hose into the back of the vacuum. Push down to
lock. (Fig. 10)
Fig. 10
12-07-03 9:15 AM