Shark VAC-OR-STEAM MV3010 Owner's Manual page 9

For best results empty the Dust Cup after
each use; empty several times during
prolonged usage or when it reaches the
MAX fill line.
NEVER OVER-FILL THE DUST CUP.
Always unplug the vacuum from
the electrical outlet before removing and
emptying the dust cup.
Dust Cup
Release
Fig. 11
EMPTYING THE DUST CUP
1 Press the dust cup release button on the top
of the unit. Pull the dust cup out of the unit by
pulling forward on the handle. (Fig. 11)
2 Hold the dust cup over a trash receptacle and
press the button at the bottom of the dust cup to
empty the dust cup. (Fig. 12)
3 Close the bottom trap door and replace the dust
cup into the unit.
4 To replace the dust cup into the unit, gently push
the dust cup assembly down and in. The dust
cup will click into place.
MV3010_40_ENG_IB_120703_1.indd 5
Fig. 12
Fig. 13
EMPTYING THE DUST SCREEN
Over time the debris may gather in the dust
screen of your Vac-OR-Steam
screen often for optimal suction performance.
1 To clean the dust screen, press the top dust cup
lid latch to access the dust screen and remove
built-up debris as required. (Fig. 13, Fig. 14)
2 Place the dust screen back into the unit and
close the dust cup lid. You will hear an audible
click when the dust cup lid is closed and secure.
3 To replace the dust cup into the unit, gently push
the dust cup assembly down and in. The dust
cup will click into place.
www.sharkclean.com
CAUTION:
Unplug the vacuum;
failure to do so might
result in electric
shock.
Fig. 14
. Clean the dust
™
5
12-07-03 9:15 AM