Appendix
Troubleshooting
Before requesting service, please try the following solutions.
PROBLEM
No operation can be
Check the batteries in the remote control. They may need replacing.
●
performed with the
Operate the remote control at a distance of no more than
●
remote control.
20 feet from the player.
Remove batteries and hold down one or more buttons
●
for several minutes to drain the microprocessor inside the
remote control to reset it. Reinstall
operate the remote control again.
Disc does not play.
Ensure that the disc is installed with the label side facing up.
●
Check the region number of the Blu-ray Disc/DVD.
●
Disc Menu does not appear.
Ensure that the disc has disc menus.
●
The prohibition
This message appears when an invalid button is pressed.
●
message appears on
The Blu-ray Disc/DVD's software doesn't support the
●
the screen.
feature (e.g., angles).
You've requested a title or chapter number or search time
●
that is out of range.
Play mode differs
Some of the functions selected in the Setup Menu may
●
from the Setup Menu
not work properly if the disc is not encoded with the
selection.
corresponding function.
The screen ratio
The Screen Ratio is fixed on your Blu-ray Disc/DVD.
●
cannot be changed.
This is not a problem with the player.
●
No audio.
Make sure you have selected the correct Digital Output in
●
the Audio Options Menu.
The screen is blank.
If the HDMI output is set to a resolution your TV cannot support
●
(for example, 1080p), you may not see a picture on your TV.
Press the ■ button (on front panel) for more than 5
●
seconds with no disc inside. All settings will revert to the
factory settings.
When the factory default settings are restored, all stored
●
user BD data is deleted.
24
SOLUTION
the
batteries and try to
PROBLEM
Forgot password
Press the ■ button (on
●
5 seconds with no disc inside. All settings including the
password will revert to the factory settings.
Don't use this unless absolutely necessary.
When the factory default settings are restored, all stored
●
user BD data is deleted.
The picture is noisy or
Make sure that the disc is not dirty or scratched.
●
distorted
Clean the disc.
●
No HDMI output.
Check the connection between the TV and the HDMI jack
●
of the player.
Check if your TV supports 480p, 720p, 1080i, or 1080p
●
HDMI input resolutions.
Abnormal HDMI
If random noise appears on the screen, it means that TV
●
output screen.
does not support HDCP (High-bandwidth Digital Content
Protection).
If you experience
Go to the contents and find the section of the user
●
other problems.
manual that contains the explanations regarding the
current problem, and follow the procedure once again.
If the problem still cannot be solved, please contact your
●
nearest Samsung authorized service center.
AllShare function
I can see folders shared
AllShares shows only files corresponding to the Image,
●
through AllShare, but I
Music, and Movie categories. Files that do not correspond
cannot see the files.
to these categories are not displayed.
Video is played
Check if the network is stable.
●
intermittently.
Check if the network cable is properly connected and if
●
the network is overloaded.
The wireless connection between the AllShare compatible
●
device and the player is unstable.
Check the connection.
AllShare connection
The IP address under the same subnetwork should be
●
between Player and
unique. If they are not, IP interference can cause this
PC is unstable.
phenomenon.
Check if you have a firewall enabled.
●
If so, disable the firewall function.
SOLUTION
the
front panel) for more than