Adjusting The Doors - Samsung RF195 Series User Manual

Setting up your French Door Refrigerator
Reassembling the freezer door (DRAWER TYPE - RF217,RF197)
1. Pull out the rails to the full length 2. Hang the freezer door front onto
on each sidle of the cabinet open slot on the sides.
evenly.
Slot
4. With the drawer pulled out fully,
insert the drawer box into the rail
system.
Reassembling the freezer door (SWING TYPE - RF195)
1. Place the hole in the bottom of 2. Replace the middle hinge connected to the freezer.
the freezer door over the right
3. Insert and tighten the screw into the left and right middle hinges with a
side low hinge.
philips screwdriver(+). Insert and tighten the 2 hex head bolts into the
left and right middle hinges with an allen wrench(3/16").
4. Replace the cap on the middle hinge.
14_ setting up
Slot
3. With the 10mm wrench, reattach
4 bolts to connect the rail with
the door.

ADJuSTING THE DOORS

Now that the doors are back on the Refrigerator, you want to make sure the Refrigerator is level so that you can
make final adjustments. If the Refrigerator is not level, it will not be possible to get the doors perfectly even.
when the Left door is lower than the Right door.
Insert a flat-blade screwdriver into a notch on the left control lever, turn it clockwise or counter-clockwise
to level the left door.
Control Lever
Screwdriver(-)
when the Left door is higher than the Right door.
Insert a flat-blade screwdriver into a notch on the right control lever, turn it clockwise or counter-clockwise
to level the right door.
Both control levers must be surely touching the floor to avoid the possible personal injury or property
damage because of tipping.
CAUTION
Control Lever
Screwdriver(-)
setting up _15