Ati Radeon 7500 Pci Graphics Controller - HP 7500 PCI Installation Manual

Overview
ATI RADEON 7500 PCI Graphics Controller Installation Guide
Figure 1-1

ATI RADEON 7500 PCI Graphics Controller

2
ATI RADEON 7500 PCI graphics controller
DVI-I VGA connector adaptor
S-Video connector
DVI-I connector
Standard 15-pin VGA connector
The ATI RADEON 7500 PCI graphics controller has a standard 15-pin VGA connector, a DVI-I
connector and an S-Video connector. The S-Video functionality is not supported by either OpenVMS or
HP-UX. There is no VGA switch; VGA functions are automatically configured through the console
firmware and software.
DVI-I to VGA Connector Adaptor
OpenVMS does not support direct DVI to DVI operation on the ATI RADEON 7500 card. The DVI port
is only useable by using a DVI to analog (VGA) adapter or cable (this part was supplied on the
AlphaServer version of the card, but is not supplied for HP Itanium). If a DVI to analog adapter or
cable is used, OpenVMS drives both the VGA and DVI interface with the same image.
HP-UX does support all video connections, including direct DVI to DVI, DVI to analog (VGA) and VGA
to VGA.
2
1
4
3
5
MR0494
Chapter 1