Step 6 - Install The Graphics Driver - HP Xw460c - ProLiant - Blade Workstation Installation Instructions Manual

Step 5 — Re-install the blade workstation
1. Install the blade workstation access panel
2. Install the blade workstation in the rack
NOTE:
connecting a keyboard, mouse and monitor to the Local I/O Connector. In either case, the blade
workstation Remote Console Mode should be set to Setup Mode, as described in the
Administrator's Guide for your operating system. Setup Mode is selected during booting of the
blade workstation.
3. Power up the blade workstation, and select Setup Mode during the boot process. On Linux, Setup
Mode may already be selected.
Step 6 — Install the graphics driver
●
Windows XP: To install the graphics driver, use Windows Explorer to navigate to where the driver
softpaq is saved. Double-click on the softpaq and follow the installation instructions. After
installation is complete, reboot the blade workstation, and set Remote Console Mode to User Mode.
●
RHEL4: To install the graphics driver, navigate to where the driver rpm is saved. As "root" install
the rpm using the command "%: rpm -Uvh <file name>". Using the option "-Uvh" will install the rpm
or upgrade an existing rpm. After installation is complete, reboot the blade workstation, keeping
Remote Console Mode set to Setup Mode (which is the mode used by Linux).
Step 7 — Verify RGS access to the blade workstation
At this point, the blade workstation should be accessible using RGS from a client computer. Follow your
normal RGS connection process to verify that an RGS connection can be made to the blade workstation.
ENWW
To install the graphics driver, HP recommends either using the iLO 2 remote console, or
Step 5 — Re-install the blade workstation 7