HP 7500 PCI Installation Manual page 13

Installation
ATI RADEON 7500 PCI Graphics Controller Installation Guide
7. Grasp the top edge of the graphics option, carefully insert it into the slot, and seat it firmly.
8. Secure the module with the screw.
9. Replace the computer cover.
10. Ensure that the monitor cable is connected to the video output connector located on the back of the
graphics option.
11. Reconnect the AC power cables to the wall outlet (or turn on the circuit breakers if applicable to
your system) to restore power to the system.
12. Perform a normal power-up of your computer system.
13. If the system is an HP-UX system, you must switch the system console over to a serial console. See
"Changing the Boot Console" on page 16.
6 Chapter 2