Pride Mobility QUANTUM series Owner's Manual page 21

Manual Freewheel Levers
Your power chair has a manual freewheel lever on each motor. Manual freewheel levers enable you to disengage
the drive motors and maneuver the chair manually. There are two different types of manual freewheel levers that
your power chair may be equipped with based on the drive motor configuration. See figures 8A, 8B, 9A, and 9B.
To operate the manual freewheel levers:
1. Locate the lever on top of each motor.
2. Pull up both manual freewheel levers to engage the motors (drive mode). See figures 8A and 9A.
3. Push down both manual freewheel levers to disengage the motors (freewheel mode). See figures 8B and 9B.
If the lever is difficult to move in either direction, slightly rock the power chair back and forth. The lever should
then move to the desired position.
WARNING! Do not use the freewheel lever handles as tie-down points to secure this product.
MANUAL FREEWHEEL LEVER
Figure 8A. Drive Mode (Drive Engaged)
Figure 9A. Drive Mode (Drive Engaged)
Quantum 600 Series
I I I . Y O U R P O W E R C H A I R
WARNING! Do not use the power chair while the drive motors are disengaged! Do not
disengage the drive motors when the power chair is on an incline or decline, as the
unit could roll on its own. Only engage the freewheel mode when on a level surface.
WARNING! It is important to remember that when your power chair is in freewheel
mode, the braking system is disengaged.
www.pridemobility.com
MANUAL FREEWHEEL LEVER
Figure 8B. Freewheel Mode (Drive Disengaged)
Figure 9B. Freewheel Mode (Drive Disengaged)
21