Pride Celebrity X LE Owner's Manual page 22

Safety Flag Bracket (Optional)
An accessory bracket for installing an optional safety
flag is mounted near each anti-tip wheel and also on
the seatback hinge. To install the flag to the rear
frame, use the smaller of the two supplied "L" shaped
hex keys. To install the flag to the seat hinge, use the
larger hex key. See figure 8.
To install the flag:
1. Remove the cap from the top of the bracket.
2. Loosen the setscrew with the supplied "L"
shaped hex key.
3. Insert the flag pole into the opening.
4. Tighten the setscrew to complete installation.
Manual Freewheel Lever
Whenever you need or want to push your scooter for
short distances, you can put it in freewheel mode.
Remove the key from the key switch.
Push forward on the manual freewheel lever to
disable the drive system and the brake system.
You may now push your scooter.
Pull back on the manual freewheel lever to
reengage the drive and the brake systems and
take your scooter out of freewheel mode.
WARNING! When your scooter is in
freewheel mode, the braking system
is disengaged.
Disengage the drive motors only
on a level surface.
Ensure the key is removed from
the key switch.
Stand to the side of the scooter
to engage
freewheel mode. Never sit on a
scooter to do this.
After you have finished pushing
your scooter, always return it to
the drive
brakes.
NOTE: If the scooter is placed in freewheel mode
(manual freewheel lever forward) while the key is in
the "on" position, the scooter will not run until the
manual freewheel lever is pushed backward and the
key is turned to the "off" position, then back to the
"on" position.
22
I I I . Y O U R S C O O T E R
or disengage
mode to lock the
www.pridemobility.com
HEX KEY
CAP
SETSCREW
Figure 8. Safety Flag Bracket
MAIN CIRCUIT BREAKER (RESET BUTTON)
Figure 9. Main Circuit Breaker Reset Button
Celebrity X LE