Pride Celebrity X LE Owner's Manual page 27

I V . B A T T E R I E S A N D C H A R G I N G
NOTE: Sealed batteries are not serviceable. Do not remove the caps.
How do I change a battery in my scooter?
MANDATORY! Battery posts, terminals, and related accessories contain lead
and lead compounds. Wear goggles and gloves when handling batteries and
wash hands after handling.
WARNING! Always use two batteries of the exact same type, chemistry, and
amp-hour (Ah) capacity. Refer to the specifications table in this manual and in
the manual supplied with the battery charger for recommended type and
capacities.
WARNING! Contact your authorized Pride Provider if you have any questions
regarding the batteries in your scooter.
WARNING! Do not replace the batteries while the scooter is occupied.
WARNING! Do not mix old and new batteries. Always replace both batteries at
the same time.
WARNING! The batteries on your scooter should only be serviced or replaced by
an authorized Pride Provider or a qualified technician.
PROHIBITED! Keep tools and other metal objects away from battery terminals.
Contact with tools can cause electrical shock.
You may need the following to change your batteries:
Metric/standard socket set and ratchet
To change the batteries in your scooter:
WARNING! Do not lift beyond your physical capability. Ask for assistance when
necessary while disassembling or assembling your scooter.
1. Remove the seat and rear shroud. See VII. "Disassembly and Assembly."
2. Disconnect the battery tie-down strap.
3. Disconnect the battery harnesses by pulling them straight up. See figure 13.
4. Disconnect the battery cables from the battery terminals.
5. Remove the old batteries.
6. Place a new battery in each battery well. Face the battery terminals toward the seat post.
7. Connect the red battery cable to the positive (+)
battery terminal. See figure 13A.
8. Connect the black battery cable to the
negative (-) battery terminal.
9. Ensure the battery terminals are covered with
the tiller boots.
NOTE: See figure 13B for correct hardware
placement for battery terminal connections.
10. Reconnect the battery harnesses.
11. Reconnect the battery tie-down strap, making
sure the strap is positioned over the frame
release lever to ensure proper securement. See
figure 13C.
12. Reinstall the rear shroud and seat.
Celebrity X LE
Adjustable wrench
BATTERY HARNESSES
Figure 13. Battery Harnesses and Battery Cables
www.pridemobility.com
TERMINAL BOOTS
27