Basic Troubleshooting; Diagnostic Beep Codes - Pride Mobility Sonic Owner's Manual

X . B A S I C

DIAGNOSTIC BEEP CODES

NOTE: Your scooter will not run unless the beep code condition is resolved and the scooter has been
turned off, then turned back on.
BEEP CODE n n
n n n (2)
n n n n n (3)
(5)
n n n n n n
(6)
n n n n n n n
(7)
n n n n n n n n
(8)
n n n n n n n n n
(9)
What if all the systems on my scooter seem to be “dead”?
n
n
n
n
n
What if the motor runs but my scooter does not move?
n
n
n
Sonic
T R O U B L E S H O O T I N G
CONDITION
Battery voltage is too low to operate the
scooter.
Battery Voltage is too high to operate the
scooter.
Solenoid brake trip. The manual freewheel
lever may be in the freewheel position.
Throttle trip. The throttle control lever
may have been depressed while inserting
the key.
Throttle trip. Throttle potentiometer fault
or speed potentiometer fault.
The scooter's motor is disconnected.
Possible controller trip. You may be
attempting to install the battery pack while
the key is inserted or the motor controller
may be in overheat protective mode.
www.pridemobility.com
SOLUTION
Charge fully until charger and any meters
indicate completion.
Call your authorized Pride
assistance.
Remove the key, then push the manual freewheel
lever to the drive position, restart your scooter.
Release the throttle control lever completely,
then reinsert the key.
Call your authorized Pride
assistance.
Call your authorized Pride
assistance.
Shut down your scooter for a minimum of
several minutes to allow the controller to cool.
Or, try reinserting the key into the key switch.
Provider for
Provider for
Provider for
35