Removing an SDRAM Module
(User-Replaceable)
The OmniBook 6000 has no SDRAM on its motherboard, but has two slots for that hold two SDRAM
modules. One slot contains a SDRAM module installed at the factory.
Description
SDRAM module, 32-MB (100 MHz)
SDRAM module, 64-MB (100 MHz)
SDRAM module, 128-MB (100 MHz)
SDRAM module, 256-MB (100 MHz)
Caution
Handle the SDRAM module only by its edges and provide proper grounding, or you might damage
the board by electrostatic discharge.
Required Equipment
Small Phillips screwdriver.
Removal Procedure
1. Unplug the ac adapter, if present, and remove the battery. Remove the secondary battery if one is
installed.
2. Turn the unit bottom-side up, loosen the screw holding the SDRAM cover (the cover retains the
screw), and remove the cover.
3. Release the two latches at the sides of the SDRAM module, so the free edge of the board pops up.
4. Pull the board out of the connector.
Reassembly Notes
Gently press the SDRAM module into the connector at about a 30° angle, until it is fully inserted.
Then press down on both sides until the latches snap closed.
2-6
Removal and Replacement
Table 2-4. SDRAM Module Replacement Part Numbers
Figure 2-5. Removing a SDRAM Module
Part Number
Exchange Part Number
1818-7950
1818-7951
F1660-69103
1818-7952
F1660-69104
1818-7953
F1654-69101
HP OmniBook 6000