Advertisement
PROBLEMS ON STARTING AND DURING THE PYROLYSIS CYCLE
I I I I
I I I I I I
I I I I
I I I I I I
24
1.
Steady door
The function selector has been turned to the pyrolysis position
with the oven door open or not perfectly closed. Or the door has
been opened before the cycle has been started with confirmation
from key 3
What to do:
Close the door and repeat the operations to start the cycle.
■ If after 5 minutes the door has not been closed door flashes
and an audible signal sounds for 30".
What to do:
Close the door, press any programmer key to silence the audible
signal and repeat the operations to start the cycle.
2.
door with AUTO flashing
The oven door has been opened after the pyrolysis cycle has
started. The pyrolysis cycle is zeroed.
What to do:
1. Close the door. P0•00 appears on the electronic programmer
display with the letter P and AUTO flashing.
2. Turn the function selector to 0 and repeat the operations to
start the cycle.
■ If after 5 minutes the door has not been closed door flashes
and an audible signal sounds for 30".
What to do:
Close the door, press any programmer key to silence the audible
signal and repeat the operations to start the cycle.
3.
F0.00 with AUTO flashing
The pyrolysis cycle has been stopped and then started again
when it was quite a way through. The message is displayed after
about 10 minutes and the pyrolysis cycle is zeroed.
What to do:
1. Turn the function selector knob to 0.
2. Wait for at least 15 minutes.
3. Repeat the operations to start the Pyrolysis cycle.
4. If after several attempts the message continues contact the
After-Sales Service Centre.
Caution: It is advisable not to stop the pyrolysis cycle and then
start it again when it is quite a way through.
Advertisement
